Substrates

Pressure sensitive coated papers, vinyl's, top coated and print treated polyester, BOPP films, polyethylene, polystyrene and paper & board stocks.

Properties

Target Viscosity: 250 - 300 cps @77°F

Cure: 450+ ft/min 300W/in Hg lamp

Gloss: 85+ (60°)

Rub: 1000+ Sutherland Rubs (4 LB Weight)

Resistance: Solvent and Water

Appearance: Milky Liquid

Shelf Life: 6 months (Unopened containers)

Benzophenone (BP): This product is formulated with Benzophenone.

BP Free Alternative: Not available

Application Suggestions

An anilox with a BCM range of 4-6 is suggested for flexo applications, although in certain cases a courser anilox may be needed to provide higher gloss. It is necessary to thoroughly coat the paper fibers or film. To achieve good cross hatch tape adhesion.

Performance Verification

After press/job set up is complete, inspect a portion of the printed web for all applicable and specified properties. These properties include but are not limited to: cure, adhesion, mar and rub resistance, product resistance, gloss, and coefficient of friction. These tests should be performed prior to beginning the full production run.

Clean Up

Use NWC10 EZ Cleaner or suitable solvent.

Storage and Handling

Proper personal protection equipment and adequate ventilation are required when handling this material. Please consult this product's SDS for details on proper handling of this material. This product should be stored in a sealed container away from heat, flame and should not be exposed to any direct light source. Otherwise, premature cure or gel could occur. The product should be mixed prior to use.